What else.. X3 Problem in 1.6, 1.4, 1.2

I

Itheran

Noob Account
Nov 22, 2004
5
0
Maryland
I just got my new X3 Modchip.. payed the extra 10$$ for 24hr shipping on a wednesday.. didnt get until the following monday.. but anyway...

I installed the chip on my newest Halo1.6 xbox with an excalibur video chip.. i installed without any hassle.. then it fragged.. tried 3 more times.. nothing.. then tried all over again inside a reletively new xbox 1.4... still frags.. Then installed it inside of my version 1.2xbox that has a workeing modchip already inside it (Cheapmod first gen), with of course doing the D0 point by itself instead of linking it, and yet still... FRAG!!! WTF!!! And i have even installed the Original hardrive to checkup on the CLOCK rumor.. still fragging.. PLEASE HELP ME!! :!:
 
T

TEaPaZ

VIP Member
Oct 28, 2004
175
0
beds
I take it you did the LPC rebuild. does it boot to M$ dash or just fragg on everything. A little more info would help to get a better answer. :D :) :D
 
I

Itheran

Noob Account
Nov 22, 2004
5
0
Maryland
TEaPaZ Wrote

PostPosted: Tue Nov 30, 2004 10:58 pm Post subject: Re: What else.. X3 Problem in 1.6, 1.4, 1.2
I take it you did the LPC rebuild. does it boot to M$ dash or just fragg on everything. A little more info would help to get a better answer. Very Happy Smile Very Happy
--------------------------------------
1) Yes i used the included pcb install method provided by the Xecuter modchips. And yes it frags on EVERY attempt
2) No i dont have ANY solder splashes i have done everything possable to make sure i didnt splash and even went over it with a Magnifyer.
3) Solder points? Nope sorry the points are VERY accurate as i have many years into soldering.
4)I have even checked the Solder points on both the Power on\off eject add-on and the modchip itself, and there is absolutly nothing wrong with it.
 
A

Audi90Quattro

Senior Member
Nov 30, 2004
146
0
Michigan
How many lights do you have lit up on top of the modchip? You should have 2. 1 for 5v and one for 3.3 v.

If you only have one light showing take the case up and boot your xbox while putting slight pressure on the lpc board. If you have any bad connections you may be able to get them to connect temp. and get the lpc board working properly.

Also did you tape up the alt 5.5v pin on the pin header? Ive read a couple posts about that.
 
I

Itheran

Noob Account
Nov 22, 2004
5
0
Maryland
Alright again.. not being rude but as i basically said "It frags on every attempt" With or withought the chip.. and yes the lights are on.. and no i didnt use an ALT 5.5v or whatever u said.. i used what the directions said and EVERYTHING was connected the way it shoulda been.. both lights were on,the eject thing was perfectly workeing. I've even installed the confounded thing inside of 2 other xbox's as i mentioned above. And it still fragged. Even inside of my first gen modded xbox fitted with a Cheap Lpc mod. and fitted what the cheaplpc mod didnt have for the pins with wires onto the back of the modchip.. so i physically solderd it to the chip. Oh yea.. and i even tried that (Solderd physical 30gauge wires to the back of the modchip itself were the pin's are visable.. more or less.)
 
You must log in or register to reply here.