What version of dashboard do I use in jrunner after I select the rgh2 bubble?

[tornado711]

Apologies for the noob question but,


I've started modding my trinity motherboard xbox 360 using RGH2 I have the NAND read and all that. Everything was fine until I got to the part wher I had to select the dash then click the RGH2 bubble. Some tutorials have said use this dash or this dash But the most common reappearing dashes to select is 16547 and 16537. Which dash version should I use I'm not sure about 16537 since my dashboard version is past that. So what dash version should I use for my trinity as of this current date?

Again sorry for the ultra noob question motherboard is trinity just incase you need it

 

[xzanox]

16547

 

[tornado711]

Thanks

 

[Martin C]

Apologies for the noob question but,


I've started modding my trinity motherboard xbox 360 using RGH2 I have the NAND read and all that. Everything was fine until I got to the part wher I had to select the dash then click the RGH2 bubble. Some tutorials have said use this dash or this dash But the most common reappearing dashes to select is 16547 and 16537. Which dash version should I use I'm not sure about 16537 since my dashboard version is past that. So what dash version should I use for my trinity as of this current date?

Again sorry for the ultra noob question motherboard is trinity just incase you need it

My 'General Q&A' in the RGH roadmap for noobies sticky covers this very question.

 

[tornado711]

My 'General Q&A' in the RGH roadmap for noobies sticky covers this very question.

Thank you for your help I may now continue but if you could answer me one question. I'm following two guides at the same time for rgh. However, eahc guide does things in a different order for example choosing dash 16547 and filling the RGH2 bubble goes at the end whilst in the other its near the beginning after you've soldered in the NAND wires. Then the create ECC and write ecc one is near the end other is near the beginning again. So am I believe I can do these seelct things in any order? (excluding writing the NAND after running through XELL)

 

[Martin C]

The J-Runner PDF tells you which order.