RGH what wires do i need? nand x by itself

[whataretheyfeedingyou]

After my failed RGH attempt months ago.

I have installed a few dual nands lately so am going to give the coolrunner another shot.

I've dug out my nand x but have lost every wire for it.

Its needs updating too still.

what wires do i need to complete a installation.

I am going to bye a qsb and coolrunner (slim)

 

[BL4K3Y]

You only really need the NAND-X QSB install cable to read/write the NAND for the first time, I also suggest ordering a NAND-X to CoolRunner cable (to program your CoolRunner with the NAND-X (after updating it) of course).

After that, you can write to your console's NAND flash using USB once you have XeLL on there but I am sure you know this already .


EDIT: to update your NAND-X (if this is what you meant?), get a USB update cable or a CK3 to NAND-X update cable (assuming you have a CK3).

 

[whataretheyfeedingyou]

these slim mobos are untouched so will need the qsbs

---------- Post added at 15:45 ---------- Previous post was at 15:39 ----------

would this be enough

• TX COOLRUNNER
• TX COOLRUNNER SLIM QSB KIT
• TX XILINX LPT UPDATE CABLE
• 68nF 50V CERAMIC CAPACITOR
• CK3 to COOLRUNNER POWER CABLE (FOR LPT PROGRAMMING)

---------- Post added at 15:45 ---------- Previous post was at 15:45 ----------

and
NAND-X QSB Install Cable

 

[BL4K3Y]

That looks fine but I suggest updating your NAND-X to v3 and using a NAND-X to CoolRunner cable to program the CoolRunner (LPT will work just the same, I just find it more convenient to use the NAND-X).

You don't need the 68nF cap, the CoolRunner has the required caps on-board for both phat and slim consoles.

 

[RROD!]

pm sent with all the bits you need to update you nandx and program your cr and rgh your slim