ANSWERED When switched to demon fans goes crazy

[qawss]

So, i installed Demon and CR3 Lite on this Trinity.
Did read out the stock nand, switched to Demon nand and wrote the .ecc file.

If i boot it with Xbox nand everything works fine.
But if i boot it with Demon nand fans goes 100% speed, also the green light will appear every 5 sec.

Any ideas?

Settings:
LK1 = Short
LK2 = Short
LK3 = Open
LK4 = All open

S2 = 1 and 5 on
S4 = All off

Demon switch: XB

 

[manwithoutname]

​

Where are your install picture? Also write stock NAND to DemoN, disable the Coolrunner and see if it boots?

 

[sabert00th]

Sometimes it just does that.
I had a Jtag and mine did the same thing.

found out I went to my settings inside freestyle and saw that the fans were up to 100%

 

[Martin C]

That's fine. the ECC doesn't include SMC config data so no fan control.

Write your stock NAND to the DemoN, then the ECC over that. You'll have proper fan control then.

 

[qawss]

That's fine. the ECC doesn't include SMC config data so no fan control.

Write your stock NAND to the DemoN, then the ECC over that. You'll have proper fan control then.

Worked like a charm!
Thanks Martin!

 

[sabert00th]

Worked like a charm!
Thanks Martin!

Martin Knows His Stuff.