Where is phat CPU_RST (top) point? (re: shielded coax wiring)

S

sofakng

Full Member
Jan 13, 2004
29
0
I've modded my Jasper (phat) but didn't have any luck with glitching so I removed the mod but I'd like to give it another try.

I've also ordered the low loss shielded coax wire from Xconsoles since a lot of people say it helps a ton, but where is the CPU_RST point on the top of the motherboard? (like shown in this thread)

Also, does anybody have any good/bad experience with using the coax wire instead of the typical Coolrunner wires?

EDIT: Oh, and does using the alternate STBY_CLK on the back of the board affect boot speed as well on the phats?
 
Last edited:
S

sofakng

Full Member
Jan 13, 2004
29
0
Thanks!! I wasn't sure if they were through-points or not.

I also seemed to damge my POST_OUT1 the first time I tried to install my RGH. I took a picture this morning but it came out terrible/blurry so I'll take another one after work.

...but it looks like the pad for POST_OUT1 is gone, but there is a small wire in the middle of the point (not mine, it's part of the PCB). I know without pictures it's hard to say, but can I just add solder to the point and then solder my wire to it?

I'll definitely post a picture after work though so it's easier to see...
 
You must log in or register to reply here.