Hey guys,
Where do I solder 3.3V and the Stby_Chk with the new V3 chip as they have removed the old solder points
Where do I solder 3.3V and the Stby_Chk with the new V3 chip as they have removed the old solder points
Where to solder with the V3 Nand-x
- Thread starter 168160
- Start date
Goldensavage
VIP Member
?????????????????Hey guys,
Where do I solder 3.3V and the Stby_Chk with the new V3 chip as they have removed the old solder points
What QSB's are you using? The nand x QSB's are not the same as the coolrunner ones.
They must be purchased seperatly. At least thats what i hope your referring to. The question is a bit vague...
First off you need these qsb:
Phat
Slim
or you can avoid QSB and just follow this: http://team-xecuter.com/forums/showthread.php?t=74689
Phat
Slim
or you can avoid QSB and just follow this: http://team-xecuter.com/forums/showthread.php?t=74689
Sorry about the poor description, I was full of excitement as I had successfully read my nand.
I've got the nandx qsb already, but they look like this http://store.logic-sunrise.com/834-1483-thickbox/nand-x-xecuter.jpg
Doesn't really matter now, cause I couldn't remove the screws to get out the motherboard, as they were stuck in like they had been glue in!!! So I decide to go with the jtag option and now it has red lights, after failing to make a good solder for the DB1F1 connection. No biggie as it was an old xbox and it was a bit of fun, thanks for all the help.
I've got the nandx qsb already, but they look like this http://store.logic-sunrise.com/834-1483-thickbox/nand-x-xecuter.jpg
Doesn't really matter now, cause I couldn't remove the screws to get out the motherboard, as they were stuck in like they had been glue in!!! So I decide to go with the jtag option and now it has red lights, after failing to make a good solder for the DB1F1 connection. No biggie as it was an old xbox and it was a bit of fun, thanks for all the help.