ANSWERED which glitch chip is the best for RGH the trinity ?

G

gojo84

I have slim proto v2 ,cr3 pro full post dgx v1.1 and 1.0 and I asume reading around that cr3 lite is the best and I'm thinking to acquire one to be sure that when I start
RGH my trinity complete it with good results
 
[AD]

[AD]

Staff member
Troll Eating Dogs
Dec 8, 2002
815
43
Bolton, Lancs. UK
I get good results with Rev c's on trinity's. (If you can get hold of them that is ;) )
 
  • Like
Reactions: gojo84
Oggy

Oggy

Staff member
Troll Eating Dogs
Mar 1, 2010
3,346
128
CR3 fullpost all the way if you have one.
 
  • Like
Reactions: gojo84
G

gojo84

ok guys thanks for your reply but I think I mes up my xbox
i started with cr3 pro ,trinity qsb v3 and qsb slim post v2
1 read 4 time my nand and saved nand 2,3,4 cause the first one was used to create the cell
2 create ECC
3 write my ECC
4 tried to boot and the cr3 pro had a red light constant and a green light flashing 3-4 secs
5 tried several tune up configs but nothing
then desoldered the cr3 nad installed the slim proto v2 with slim post qsb v3 and done the the exact steps like cr3 pro but with slim proto no green light and no glitches time in cr3 rater
I desolder every thing and tried to boot with stock but nothing the xbox starts up with just only a red light ,flashed the nand I stored from the 4 reads of the original of the starting process but still the same ,please what should I do buy a new xbox and started over cause I'm decided to RGH a trinity on cost to destroy till I accomplished what I started or there is still hope for this crappy one ?
 
T

teozfrank

Senior Member
Jan 2, 2013
115
0
Ireland
www.teozcommunity.com
gojo84 said:
ok guys thanks for your reply but I think I mes up my xbox
i started with cr3 pro ,trinity qsb v3 and qsb slim post v2
1 read 4 time my nand and saved nand 2,3,4 cause the first one was used to create the cell
2 create ECC
3 write my ECC
4 tried to boot and the cr3 pro had a red light constant and a green light flashing 3-4 secs
5 tried several tune up configs but nothing
then desoldered the cr3 nad installed the slim proto v2 with slim post qsb v3 and done the the exact steps like cr3 pro but with slim proto no green light and no glitches time in cr3 rater
I desolder every thing and tried to boot with stock but nothing the xbox starts up with just only a red light ,flashed the nand I stored from the 4 reads of the original of the starting process but still the same ,please what should I do buy a new xbox and started over cause I'm decided to RGH a trinity on cost to destroy till I accomplished what I started or there is still hope for this crappy one ?
Click to expand...
no green light usually means you have a bad connection on cpu_rst did you check it was soldered correctly? Post photos. Correct me if Im wrong guys!
 
You must log in or register to reply here.