Why would my DVD's skip the menu screen??

[JLS24]

Im trying to figure out why my dvd's jump stright to the ovie, or for instance on the family guy dvd it jumps striaght into the 1st episode then after its over it goes back to my XBMC screen.(XBMC is my dash at the moment) Im sorry if this question doesnt belong in this forum I dont the X3 has anything to do with it. but does anyone have any ideas?

 

[PhatheadWRX]

XBMC does not support Menus (goes straight to movie). Get the DVD Dongle (ms dash) or DVDX (app) and set them as the DVD player in your XBMC config.xml

 

[KingDRAGON]

You can also use the DVD player included in Avalaunch 0.49.2 dash.

The DVD features of XBMC are based on mplayer which does not support DVD menus at the moment. XBMC DVD playback does not have either the option to preselect default language & subtitles and set them to be always on, so each time you have to tell it to do so. Sucks!!!

 

[PimpLou22]

Need help with LED hookups.

I have already wired my Blue leds with the right resistor for a 12v power supply. I tried hooking it to the 12v and ground under the power brick plug in on the mother board but the LEDs don't turn on when I turn on my 360. Are there any other 12v points I can use or any advice you can give me? I'm kinda new at this so any would help.

 

[Smiley]

Re: Need help with LED hookups.

those are good points for power and ground the only thing i would check is to make sure the resistors your using aren't 68k ohms or 100k ohms, just 68 or 100. i made that make mistake when i first started modding.

 

[PimpLou22]

Re: Need help with LED hookups.

yeah man, i ended up getting them working right after i posted this. go figure. but yeah i had everything right, just the solder wasn't sticking to the terminals.