Ahhh i never even noticed that thankyou i will give it a try whoohoo all is not lost then.
when you say use the falcon 5770 files does that include using the xbr falcon files or do i use the xbr zephyr 8955_3b files? sorry for the question but im trying to follow the jtag tut in the jtag section and it doesnt mention about using falcon files on a zephyr.
Thanks for all your help so far martin, i have wrote xellous to my console using those setting you gave me and i get a single red light on the bottom right hand corner of my light panel and the tv screen doesnt light up. i have tried to boot up the xbox by using both the eject button and the power button. i have reflashed my original nand back onto the console and it boots fine, could you please shed some light on what i am doing wrong. P.S i have had to use the alternate DB1F1 contact point as shown in this thread for my jtag wiring point green wire http://team-xecuter.com/forums/showthread.php?t=55120&highlight=DB1F1
Not sure - you'll need to post pics of what wiring config you used. Did you change any settings in JTAG Tool?
Sorry mate i have just upped 2 more photos there is a diode in the line, i have also tried the QSB board switch to on and off because i wasnt sure what it should have been set too.
I was trying to pick up on an alternative DB1F1 point to solder too as the original point has burnt off on the top of the board, (it was already missing when i had it. i was following the tutorial in this link. http://team-xecuter.com/forums/showt...ighlight=DB1F1.
