Hey guys I seem to have misplaced my white shielded wire for an RGH 2 install, can that wire be replaced with any shielded wire any specific wire needed?
Pls and thank you for the help
Pls and thank you for the help
wire replacement?
- Thread starter DormantBeast
- Start date
hersheys247
VIP Member
Would u also happen to know if on a rjtag, I have the qsb for the ribbon but not the other qsb is the one i dont have needed for install? I didnt seem to find a wiring for rjtag w/out qsb :'(
Last edited:
Slayertex6
VIP Member
Taijigamer2
VIP Member
Rjtaguses standard jtag wiring so use ROL wiring or AUD clamp wiring. AuD clamp is better for HDMI consoles.
If you need shielded wires, the one that they use is type lmr-100a.
You can also use RG-174 which is cheaper and easier to find.
Shielded wire (or coax) is important in Trinity but for Corona, the blue wire is fine.
You can also use RG-174 which is cheaper and easier to find.
Shielded wire (or coax) is important in Trinity but for Corona, the blue wire is fine.
This would be on a zephyr now with 9199 dash so it's now a rgh not a 2. Thought i would update u guys, but i will try the blue wire so from cr to MoBo no grnd needed