LITEON DG-16D2S Won't work now?

[CptJackRabbit]

Was following this guide ( http://team-xecuter.com/forums/showthread.php?t=69805&highlight=DG-16D2S ) which was working beautifully. But after step 11, it returned an error... And now nothing works for it. It is now stuck at no drive detected, and Jungleflasher, if I Intro it, just keeps waiting for the power cycle. If I power cycle, nothing happens. What do I do?

Getting Status from port 0x0000
Invalid Status 0x80
DVD Key already matches
ID strings already match

No Drive Detected! DVDkey files extraction aborted!


No Drive Detected! DVDkey files extraction aborted!


No Drive Detected! DVDkey files extraction aborted!


Getting Status from port 0x0000
Invalid Status 0x80
Sending Vendor Intro to port 0x0000
Status 0x80
Re-sending Vendor Intro:
.............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
Device Intro failed!

 

[ramaroodle]

A little more info. maybe? Chipset? USB Pro? Probe? Power to drive? FW version? Did you try rebooting?

 

[Fisticuffs]

You say everything was good till step 11, Do you have a dummy.bin?

 

[talby71]

and a full jf.log would have been more helpful

 

[CptJackRabbit]

You say everything was good till step 11, Do you have a dummy.bin?

I do have the dummy.bin

And I dont have the full JF log... I had closed it out when it just kept trying to intro...

---------- Post added at 01:46 ---------- Previous post was at 01:43 ----------

Chipset?

USB Pro: USB Pro V2
Probe: Probe 3
Power to drive: Via USBPro V2
FW version: Working on LT3 ... unless you mean original than its 83850C
Did you try rebooting: Yes

 

[Fisticuffs]

If your sure the dummy.bin is from that drive, Run JF as admin, Then just load the dummy.bin as target in firmware tool and click Lite-on Erase in the MTK flash tab and follow the on screen instructions. Also what dashboard was it on??
Edit: And when you X out of JF (close) JF it asks you if you want to save your JF.log, Can't understand why you don't have it.

 

[Joo C]

Load your source file into JF and go straight to write on the mtkflash32 tab, power cycle when asked and it should write (u have to be sure you have your dummy bin!)

 

[Fisticuffs]

Load your source file into JF and go straight to write on the mtkflash32 tab, power cycle when asked and it should write (u have to be sure you have your dummy bin!)

Is there an Echo in here ??

 

[CptJackRabbit]

Load your source file into JF and go straight to write on the mtkflash32 tab, power cycle when asked and it should write (u have to be sure you have your dummy bin!)

Well that got it into Vendor mode.. I think I can get it from here. Thanks!