worked fine, now frags

[annoyance]

first of all, this is a 1.3 box with a pin header installed. it worked fine for about a month.

now all of a sudden it powers up twice then frags on the third, with no video or sound.

when enabled, it frags

when disabled, it frags

when boot to backup, it powers up and stays powered up, but blinking green ONLY. still not video or sound.

also, when booted to backup the dvd drive does not eject. it makes a click noise and the HD led lights up, but the tray does not come out.

i opened it up and noticed that both LEDs on the x3 are indeed on.

SO, any ideas on what to do? im guessin im going to need to do some soldering work based on previous posts, but that is odd considering the xbox was working fine for a while. any specific pin i should be aware of? and does the weird behavior when booted to backup signal anything?

ANY HELP WOULD BE APPREACIATED!

thanks

 

[annoyance]

it also frags without the chip in, which is weird considering it didn't frag when booting to backup...

 

[annoyance]

bump for help...

please?

 

[tehsoul]

maybe your d0 wire came loose?

take your mobo out and see if you can see anything wrong

 

[Xecuter]

FRAG with no chip = damage to xbox motherboard / onboard flash rom

 

[polar]

No light on xbox and cant connect controllers?

I have this problem, there is no light on my xbox360 when i start it up and my controllers wont connect to the xbox. Now i have tryed alot to get the controllers to sync but no luck.
Tryed the sync buttens on the xbox and the controller at the same time and then the xbox first and on and on. tryed to holde the sync butten down in 30sec on the xbox, then turning off the xbox. I have tryed everything hmm. heeelp me.

 

[polar]

Re: No light on xbox and cant connect controllers?

I bought a new RF Board and it worked 100%