RGH Worked like a Charm. Slim Install Success

L

lefos

Junior Member
Dec 11, 2011
13
0
USA-Massachusetts
This isn't a question but I guess something to note.

I did the RGH via NAND-X and Coolrunner and everything went perfectly! I did have one issue with dashlaunch and I just wanted to point this out for other new RGHers

If you set dashlaunch to default to another dashboard like freestyle, the console will give a red light, or red ring. I new I was going to install freestyle, so I set the path before actually putting the files on the hard drive, and lets just say it wasn't happy.

Otherwise I had a clean install and it went great! Just have to keep up with these dashboard updates... There have been what, four in the past two months?
 
ball00

ball00

VIP Member
Nov 8, 2011
632
0
France
I thought dashlaunch would try to boot the next dashboard on its ini file if it didn't find the first one. When I haven't placed the freestyle dash on the hard drives after an install it always boots the stock dashboard. Never had a red light from not having freestyle dash installed as yet.
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
Never had this problem either - if the default isn't there, it'll boot to stock.

If this isn't happening, you've made a boo-boo somewhere.
 
E

esbmaepo

VIP Member
Oct 2, 2011
461
48
Esbjerg - Denmark
Martin C said:
Never had this problem either - if the default isn't there, it'll boot to stock.

If this isn't happening, you've made a boo-boo somewhere.
Click to expand...
I actually have the same issue with a JTAG Falcon that I did yesterday. Installed it with dash 14699.

It boots fine to Freestyle but when I try to go back to stock dash it gives me a red light (error E71). But I'm pretty sure its caused by a single bad block.
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
esbmaepo said:
I actually have the same issue with a JTAG Falcon that I did yesterday. Installed it with dash 14699.

It boots fine to Freestyle but when I try to go back to stock dash it gives me a red light (error E71). But I'm pretty sure its caused by a single bad block.
Click to expand...
Then why didn't you sort the bad block?
 
E

esbmaepo

VIP Member
Oct 2, 2011
461
48
Esbjerg - Denmark
Martin C said:
How can you forget? Multi_builder does it for you. There's nothing TO forget.
Click to expand...
Yes I know....

I'm using Nand Flasher 360 to read/write nand and it has an option to remove bad blocks. But since that bad block already has been removed by Multibuilder I should not have used that option.

At least I hope thats the problem....
 
You must log in or register to reply here.