X2.3b to X3 old d0 Vs. X3 d0

[Kricket]

ok i had a x2.3B and i got a X3 well according to the install guides i'm finding the d0 for x3 is on the back of the board and the x2.3b d0 was on the frong of the board next to the lpc. now i usually tried installing the wire install and just cutting my d0 cable from my x2.3b and soldering on the d0 cable from the x3 well it didn't work my xbox booted rebooted in about a sec and and booted to a frag the 3 time when i tried turning it on now on my x2.3b i found this was do to the d0 point being loose or something well i did something stupid and the wire i had soldered into the old do came out. so where should i solder d0 this time where i had it in x2.3B or the x3 recomended d0.

also from where the x2.3b d0 wire was there's a small lil piece still in there so if i solder to the back of the board for the x3 d0 will that have any effect. please help me i miss playing halo 2

 

[Kricket]

also why is the red wire on the wire install longer than the rest of the wires. is that sopposed to go somewhere other than the LPC why doesn't Xecuter have any wire install tutorials. i see too many Xapter and Pin header installs

 

[XCronus]

there are wire install tutorials.......

but anyways just do a pin header install
its much easier even if you have a 1.0 and have to desolder the holes
use the d0 on the back

 

[Kricket]

ok i think i broke the tracer on LAD0(purple wire on the LPC) is there a alternate place to solder this wire ??