x2.6 frags

[lawreaga]

So I accidentally flashed the x2.6 with a 1.0-1.5 bios and my xbox is a 1.6 now the xbox turns on, turns off, turns on, turns off and then turns on with frag. The xbox is fine when the chip is turned off. so is there a way I can fix this without a x2 programmer?

 

[DJBOOBY]

If Its A V1.6b Change Switch Setting To Bank 2 If Not Programmer Is Needed

 

[lawreaga]

is it possible to put the chip in a v1.0-1.5 xbox and go into it? if so. how?

 

[DJBOOBY]

you cold try solderless install then flash chip with v1.6 bios in v1.0 v1.5 xbox or flash flashbios to it allso but it going to cost you money for the solderless so buy the programmer

 

[lawreaga]

I'm not understanding what you said here.
I have 2 xboxes. 1 is a 1.3 with a x3 chip that works perfect and the other is the 1.6 with x2.6 chip that frags because of the wrong bios.

can I take out the x2.6 chip and put it in the the 1.3 xbox since everything is already soldered so that I can gain access into the x2.6 chip?

 

[DJBOOBY]

place x2.6 in 1.3 box then flash v1.6 bios to it then place back into v1.6 xbox
you do not have to resolder it will fit as it the same you will need to put the x2 switch to get it to work