X2.6 to X3 Upgrade Problem

[x2gamer85]

I have a v1.0 box with a x2.6 lite modchip that I installed using the pin header method almost 3 months ago. I upgraded the modchip to an X3 using the existing pin header and D0-LAN-HDD wire harness already in my box. After putting it all together, I plugged in the power cable and the box came on by itself. It attempted to boot and then shut off 2 times, and then on the 3rd attempt, it remained on and the Eject button flashed orange and red. No video during the boot attempts. I pressed the on/off button but it wouldn’t shut off. I had to unplug the power cable. I rechecked my harness connections and verified all connectors were properly seated. All good. I tried it again and the same thing happened. I then removed the External Switch and wire harness and tried it again. Again, the same thing happened, it attempted to boot 3 times and then flashed orange and red. I then removed the X3 modchip and reinstalled my x2.6. The box works fine with the x2.6 enabled and disabled. I checked the hardwired harness on the Reset/Eject Adapter for continuity and all wires are good.

This appears to be a faulty modchip or Reset/Eject Adapter problem to me. Any suggestions??

Thanks/X2gamer85

 

[lickballs]

im having a similair problem and to stop the on/off on /off lockup is to switch to the other bank on the front switch panel which should allow you to access the flash bios screen which is where im stuck now so if you get past that please in form me how t.i.a.

 

[lickballs]

also if you are able to assist me im using the 2.6 hard wired on a 1.4 box

 

[romracer]

X-S: HDDHackr v1.30 Build 20110303

Team MODFREAKz (TMF) released a new version of HDDHackr, a tool that allows you to use some Western Digital HDDs as Xbox 360 HDD.

What's new/fixed:
* SATA and IDE port scan improved (The ports are now enumerated with the CONFIG_ADDRESS and CONFIG_DATA register instead of using interrupts)
* PATA and SATA controllers list updated
* Automatic Device Reset
* Code optimization to work with modern SATA2 controllers added (Remember to set SATA controllers to IDE and not AHCI mode)

Official Site: n/a, by Team MODFREAKz
Download: here
News-Source: xboxhacker.org

Source