X3 1.6 and 1.6b D0 in the Tutorial problem

[rominia]

I have noticed a lot of posts about the D0 point and how screwed up they got on this point and some said they found out they soldered something in the wrong spot. However I realized when I was doing my first install that I indeed did install the D0 point into the wrong spot and here is the picture from the install.

http://www.teamxecuter.com/x3/tutorials/16/x3_16bottom.jpg

Look at that picture closely theres 2 spots circled 1 is pointed to that is the correct spot to solder lol. I soldered to the other circled point by mistake and I'm sure that others have done the same. I'm just letting everyone know about the dreaded D0 point issue.

 

[nospmohtkcin]

I don't see the problem. The D0 is circled and and big arrow pointing to it. Aslong as you took more then 2 seconds looking at the picture you would know the correct point

 

[rominia]

i was just saying t his to let people know incase anyone had the d0 issue of it fragging on the third boot. other people had this problem i recall a lot of people saying it was the d0 point in the wrong spot so if someones box is fragging and they just installed it check the d0 point is in the right spot thats all im saying. i am not saying the tutorial is wrong its just a little confusing to some people i know im not the only one that had this problem

 

[tehbrad]

CKv3 and Probe?-BenQ

Hiya guys,I flashed my Xbox a week ago but was too impatient to get a CKv3 :roll: ,now Im going to get one and I know to purchase this one http://www.modtraders.co.uk/xecuter-ck3pro-rev-d.html

But is the Probe necessary if I have a BENQ drive?I heard its used for LiteOn drives but Im not sure :?:

 

[denka]

Re: CKv3 and Probe?-BenQ

There's no need for the probe if you have a benq drive.