X3 and Programer??

[FiReSiDe]

I just revived a dead xbox, badly burnt trace, well i got it to boot to default M$dash, i then hooked the chip up (installed D0 during repair) great it booted, got to flashbios 3.00.... http flash.... it spit out an error (to blurry to read) after a few moments
i rebooted and try to gain access to alternate banks, and the back up bios, to no avail. waht the hell happened, thats twice http flash has ****ed me.. ohwell...
i rechecked my solder points (for no reason, box wasnt moved why would there be a problem with contacts?)

I have the usb programmer for the 2.x chips im wondering if that werks with the x3?
i tried to fit the chip but a pin hole is filled in on the x3 chip, can i just shift the chip to the right?

i want to say i read a post similar, but i am unable to find it now

um x3 chip on v1.1

 

[FiReSiDe]

ok.... no i cant just shift the chip to the rightit wouldnt do any good any way? because x2bm is looking for the 2.x line of chips? ok so is it possible to externally flash the x3
i would like to have the correct bios loaded on the chip that way im not trying to figure out wahts ****ed the chip or the box.

 

[FiReSiDe]

damn im beginning to think this box is burnt, im unable to get M$ dash now, and my D0 is flawless, i think its gone.... i dont know ill keep ya posted good night