X3 blue led on chip when plugged in and not on
- Thread starter drsuse
- Start date
Redneck
VIP Member
Ms25 w/1.61 getting e71 help pls
Ok so i have been at this one for a week and i can not seem to find any info on it i have a benq that i modded that works great. I replaced the original drive with a new ms25 and just switched the board inside. Unfortunately, i a am trying to mod my friends ms25 everything seems to be great in jungle flasher (i have done these with older firmware) but when i plug it up to the tv it dose these thing. I replaced the original drive with a new ms25 and just switched the board inside
freezes at the initial loading screen
if y or sync button is held gets to dash but freezes after a few minutes
gives e71 error often after initial boot or upon attempt to load disc
it has samsung 1.61 spoofed for ms25
the most current dashboard that came out 4/6/10 ver 2.0.9199.0
once in a while the ring on the xbox and controller just flash in unison and the controller will not work
I restored it to the stock firmware and i runs like a champ i am pretty sure i flashed it properly i have tried multiple times. Any and all help that may lead to me fixing this thing would be great.
Ok so i have been at this one for a week and i can not seem to find any info on it i have a benq that i modded that works great. I replaced the original drive with a new ms25 and just switched the board inside. Unfortunately, i a am trying to mod my friends ms25 everything seems to be great in jungle flasher (i have done these with older firmware) but when i plug it up to the tv it dose these thing. I replaced the original drive with a new ms25 and just switched the board inside
freezes at the initial loading screen
if y or sync button is held gets to dash but freezes after a few minutes
gives e71 error often after initial boot or upon attempt to load disc
it has samsung 1.61 spoofed for ms25
the most current dashboard that came out 4/6/10 ver 2.0.9199.0
once in a while the ring on the xbox and controller just flash in unison and the controller will not work
I restored it to the stock firmware and i runs like a champ i am pretty sure i flashed it properly i have tried multiple times. Any and all help that may lead to me fixing this thing would be great.