X3 blue led on front panel doesnt work on a 1.6 install

[TucDemonic]

when i install the x3 in a 1.6 MB it will light up the red when disabling it but the blue light does not work, though it works on a 1.4 install... any help would be appreciated...

 

[TucDemonic]

just as an added note, the box will boot in to the x3 w/o a problem, but it just wont light up the blue on the 1.6, it lights up on the 1.4. i have searched the forums and could not find this particular problem.

 

[hung]

Do u get both lights on the X3 chip when you install it on the 1.6?

 

[TucDemonic]

ok dont have a clue as to what was wrong it is now working. sorry for takeing the time out from you. thanks for responding

 

[Pcaddict]

Well your not the only one who has that happening. Installed X3 on a 1.6 and when go to boot I get Red (Disabled) on boot and will not go to enable or other, Chip flash protect on chip board is off. Any idea

 

[hung]

Pcaddict try checking your soldering points for bad connections and see if you have the 2 blue leds lit up on the X3 chip

 

[Pcaddict]

The Led's on the chip light up. On power up it shuts off and on then comes on with green and red on the power button. With the chip front switch still red

 

[hung]

Does it boot up to ms dash when the chip is removed or disabled?

 

[Pcaddict]

Yes it boots up to ms dash on boot

 

[hung]

Its best to check all your solder points carefully and check you have soldered all the points on the lpc rebuild

 

[Pcaddict]

Thanks checking on all that right now (Crossing Fingers) So far all look ok besides about 2. Will see what happens thanks in advance

 

[hung]

You have soldered the d0 wire to the d0 pad on the LPC rebuild PCB, yes?

 

[Pcaddict]

Not sure what you me can you explain more I went off the tutorial that the site has for install on a 1.6

 

[hung]

Did you use the purple pcb board to to your lpc rebuild?

 

[Pcaddict]

No I did not I didn't see anything for that on the install tutorial I just went off from that am i missing something

 

[hung]

so you used wires to do your lpc rebuild? (tutorial blue wires)

If this is the case then ignore what I said about the "d0 wire on the d0 pad on the LPC rebuild PCB"

 

[Pcaddict]

Well yes was I suppose to use that or no

 

[hung]

Either wire or PCB lpc rebuild work fine

 

[Pcaddict]

Well yes was I suppose to use that or no

 

[hung]

You only do the rebuild if your xbox is a version 1.6 or 1.6b