Soldering that point didnt work and now with the chip removed the xbox FRAGs. the point i missed is the one that connects to the 5th point on the bottom of the lpc rebuild and to the motherboard
X3 loads only if disabled \1.6
- Thread starter dekos
- Start date
What do you mean by 5th point??? Pin 5 on the actual LPC? or have you assigned some sort of numbering to the pads on the LPC rebuild?dekos said:
If possible take a picture of your install and post it here.
ok the points That weren't soldered well are circled in blue and the one circled in red is the point i missed. i soldered it but it still wont load there is no response from the chip and everything is soldered corectly now
the blue circle on the right is pin 9. Just so we know were you getting 2 blue led's lighting up on the chip
then you should concentrate on soldering pin 9 and 15 untill you get 2 blue led's on the chip. You can connect a wire to both of those pin too, to give you a better chance of getting 3.3v
so you want me to connect these two points in red and is there any specific guage of wire i should use
yes. If your using that board pin 9 and 15 are connected through the trace on the board so just desolder those points and resolder them till you get the 3.3v leddekos said:so you want me to connect these two points in red and is there any specific guage of wire i should use
is the 3.3v led right next to the other one or where is it the one that has been lighting up is near the connection for the switch to the chip
Interesting info on Fable 3 and Firmwares....
TO make this quick:
Ive been looking all over xbox scene and it seems this might be true for ANY drive.
If you have a no stealth ixtreme FW on ANY drive, Fable 3 will boot after the dash update.
If you have the LT firmware, it will NOT boot after the dash update.
Thoughts? Anyone else test?
TO make this quick:
Ive been looking all over xbox scene and it seems this might be true for ANY drive.
If you have a no stealth ixtreme FW on ANY drive, Fable 3 will boot after the dash update.
If you have the LT firmware, it will NOT boot after the dash update.
Thoughts? Anyone else test?