I have installed a few X3 chips in v 1.6 xboxs with no problems. I installed one in a V 1.1 like in many posts everything was good till i flashed and got a blank screen. i then tried resoldering a few times with same results. i flashed on bank 5 xecuter 2 bios and that worked fine. but i was determined to get the xecuter rocks my box so i used the backup dip settings off on off off to reflash and forgot to change dip settings before flash. now when it boots the screen is blank. when i try to use bank 5 where i had xecuter 2 bios it dont work now. it comes on and off a couple of times and then the xbox power lite flashes red and green. i have tried every dip setting i can think off and nothing. I have tried pushing power and eject but not sure if i am doing this right but power just shuts off.
is there any way to Re flash this chip?
is there any way to Re flash this chip?