i think i messed my box and chip up...to start with i have 5 xboxes and five x3 chips....i was installing x3 chip to a 1.0 box (that was already in another 1.0 box and working),just to see if my solder points were ok on my new install.turned it on and .the chip did not light up....that is when i noticed the chip was in backwards.... fliped it around,turned it on and chip lit up but switch logo is red and fragging in all banks....put that same chip in another working 1.0 box same thing chip frags and logo red all banks (the logo light goes from bright to dimm,,,like it has a short)any way i can live with chip being bad but for the big one my box...
i used my working 1.0 box to flash another x3 chip (both work fine)...i took that working chip and placed it in the xbox(that had the chip backwards prior)
frag in all banks but logo blue...the strange thing is the backup bank....hold both down machine turns off one time then boots to blank screen....
can give more info if needed....
i used my working 1.0 box to flash another x3 chip (both work fine)...i took that working chip and placed it in the xbox(that had the chip backwards prior)
frag in all banks but logo blue...the strange thing is the backup bank....hold both down machine turns off one time then boots to blank screen....
can give more info if needed....