I installed my x3 without much problem, and finally flashed the bios. when i first plugged the switch in it lit up fine, but i hadnt stuck it to the box yet and i needed more slack on the line to do it, so I went back in and moved the chip over a cm or two. any ways when I plugged it back in the switch didnt work. So I just continued with the flashing of the bios, and after its all finished I wanted to see if I could get the switch working. when i plugged it in and booted, i got a beep restart and FRAG, i tried changing the banks (i think it was on on off off off), anyways the thing still didnt show any lights, and when i unplugged the switch it booted fine. is the switch faulty, is there a bad contact? okay thanks.
x3 switch and FRAG
- Thread starter crazyclown1337
- Start date