X360USB PRO V2 Switches Guide

Status
Not open for further replies.

Ubergeek

Xecuter Groupie
Feb 24, 2003
6,272
0
California, USA

Note 1: 12v Power has to be connected to this device. Standard USB to Molex 5v will not be enough.

Note 2: If your system experiences lag or JF freezes when performing operations such as Drive Intro, or if things like auto slimkey are not working then make sure the AUX Power Switch is set to OFF (switched towards the USB port)

Note 3: The Update switch is only ever used when you need to upgrade the firmware of the X360USB PRO V2. Make sure the switch is to the OFF (away from the reset button). If you have the switch set to ON (Bootloader Mode) then it will not install the X360USB PRO V2 drivers or even detect as an X360USB PRO V2, but a generic Windows HID driver which enables you to upgrade the firmware over USB.
 
Last edited by a moderator:
Status
Not open for further replies.