Hi there,
I have installed a x3ce on a xbox 1.0 and have supposedly flashed it right with the x3 3294 bios from xbins. I flashed my chip through the network and it seems to have flashed correctly as it shuts down at the end like it is supposed to. When I try rebooting to see if it works it tends to shut down after a second or two and sometimes gives me a loud beep also. Any help would be greatly appreciated.
Things I have checked so far:
- The chip itself has a reversed setting for protect and unprotect, so i went with the red light instead of the green.
- my bank selection is off on on off off the first off being the protection button on the Control panel.
- checked all my solder point but don'e seem to have an issue.
But i am still dumbfounded by the shutdown issue. is there anything else or solution that anyone knows of that they can enlighten me about.
I have installed a x3ce on a xbox 1.0 and have supposedly flashed it right with the x3 3294 bios from xbins. I flashed my chip through the network and it seems to have flashed correctly as it shuts down at the end like it is supposed to. When I try rebooting to see if it works it tends to shut down after a second or two and sometimes gives me a loud beep also. Any help would be greatly appreciated.
Things I have checked so far:
- The chip itself has a reversed setting for protect and unprotect, so i went with the red light instead of the green.
- my bank selection is off on on off off the first off being the protection button on the Control panel.
- checked all my solder point but don'e seem to have an issue.
But i am still dumbfounded by the shutdown issue. is there anything else or solution that anyone knows of that they can enlighten me about.