Hello all,
I just got my X3CP from System-Mods, and in the process of installing it (still not sure how this happened, I was VERY careful) I must have somehow damaged the socket on the inside of the control panel bank switch that the plug connects to on the PCB for the switch buttons.
I am still not sure how I did this, as the cable is super-glued into the CP assembly and basically acts as a strain relief at that end.
In any event, can I get a somehow get a replacement or send this portion somewhere for repair/replacement?
Thanks,
R
I just got my X3CP from System-Mods, and in the process of installing it (still not sure how this happened, I was VERY careful) I must have somehow damaged the socket on the inside of the control panel bank switch that the plug connects to on the PCB for the switch buttons.
I am still not sure how I did this, as the cable is super-glued into the CP assembly and basically acts as a strain relief at that end.
In any event, can I get a somehow get a replacement or send this portion somewhere for repair/replacement?
Thanks,
R
