X3CP Fitting Issue

[maegus15]

I purchased the black X3CP and the lower right clip under the lcd doesn't seem to want to lock in. I have taken off and put it back on several times in several ways and the same problem occurs every time. Also, when putting the cover back on the xbox I have to force it on over the front lip of the Control Panel so I can screw it in. Every time I get it put back together the on button for the Xbox sticks and I have to take it back apart. Has anyone else had this issue and if so what have you done to fix it?

 

[Dasgooch]

I was having the same problem. If you take the power/eject board out and look around where the power button sits there were two little "slivers" of plastic sitting right next to the hole. I trimmed these down with a sharp knife so they were even with the rest of the face and it worked like a charm.

On another note getting the X3CP fitted aside from that problem IS A BITCH! Routing the cables inside are a joke, they need to be a couple inches longer but noo..... I had to dremel my case a little more than I would like to get that front panel to sit flush.

 

[maegus15]

I think Team Xecuter did a pretty awesome job for doing that front panel from scratch, I just think that maybe since they have all of this feedback they can do some updates to the molds so that future batches wont have these issues. I know issues are to be expected so im not mad, but it's a little annoying for having to pay 85 dollars. Hopefuly Team Xecuter will have something to say about it and also have a solution for it. Oh, and thanks for the advice... I will have to try that.