Just wondering if it's possible to put a Xapt3r 1.6 on a 1.0 MB. I figure there are 5 legs and 4 are for the rebuild and one is for the d0. Just don't use the rebuild legs.
Off the top of my head I'm not sure. But, if you take a multimeter and test that each post on the bottom (the parts that sit on the LPC holes) properly connects to the same post on the top (where the chip plugs in) then I think you should be OK. One of the top posts should link to the D0 leg and I don't think it will have a post on the bottom of the adapter.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
