i stripped the screw hole on a clients xbox how can i install it with out usiing the supplied screw bolt thing can i use a norman screw?
thebroken
thebroken
Xapt3r not stupid
- Thread starter thebroken
- Start date
First off, I have never used Xapter, and I claim NO KNOWLEDGE OF IT.
But, If I am correct in assuming that if you can find a screw that will hold Xapter to to the ground then you should be fine (based on MY knowledge of X2.3 light). Maybe something a with a little bit thicker "thread" on the screw to dig into the plastic screw hole.
XECUTER - suggestions?
But, If I am correct in assuming that if you can find a screw that will hold Xapter to to the ground then you should be fine (based on MY knowledge of X2.3 light). Maybe something a with a little bit thicker "thread" on the screw to dig into the plastic screw hole.
XECUTER - suggestions?
stripping it = not folowing the manual
i cant really give personal help to those who cant even read a manual
i cant really give personal help to those who cant even read a manual
harsh.i would suggest you fill the hole with pieces of a toothpick and then put the screw back in, this will work just fine.
typical xecuter response - KMA or FOAD.
typical xecuter response - KMA or FOAD.
Kma? Foad?
oh and if you stripped the screw just solder it, when it is the pin header
oh and if you stripped the screw just solder it, when it is the pin header
Last edited: