xapt3r on a 1.0

[EyeHeartCocaCola]

how does a xapt3r work solderlessly on a 1.0 board? the lpc port is already filled in.

 

[HarshReality]

I followed the older xapt3r guide, pessed it firmly and secured it with no problems at all. Others will say you need to get a braid or pump and remove the solder fillins because it could shake loose.

I personally havent been able to shake mine loose and I have given it an honest attemp

 

[EyeHeartCocaCola]

managed to desolder it, but where does the d0 connect on a 1.0? i didnt find it anywhere, not even ont he old xapter tutorial

 

[Bad2bones]

http://www.teamxecuter.com/x3/tutorials/pinheader/v10v15/x3_bottom.jpg

V1.0 DO point is on this jpg

 

[EyeHeartCocaCola]

i dont think thats the d0 for the xapt3r, im looking for the place where u connect the wire comming out of the xapt3r

 

[jriggall]

Try this guide.. It is not for the chip you have but it shows the D0 point on the V1.0 board. That is what the wire from the Xapt3r will go. And as stated above you dont need to remove the solder, it works great after you put it tight on the board. Good luck.

Check out page 11 of the Tut. and you will see the D0 point
http://www.midsouthmods.com/files/iceguide.pdf

 

[EyeHeartCocaCola]

thanks, got it. everything looks good except only 3 leds are blue the 4th one is off, is it supposed to be like that?

 

[EyeHeartCocaCola]

nevermind, all works now, thanks alot guys