Xapt3r v1.6 Help

[Susaski]

I didn't know if to post this in this area or not but there isn't a section for the Xapt3rs but I have a x2.6 and I'm trying to install this xapt3r 1.6 on my board and its a 1.6 board. But the only probably I'm having is for the B and C holes to put the pins in they are covered up and looks like they were never made into holes at all but I could be wrong due it being smaller to the human eye so I'll go pick up a mag for it to get a better look. Basically I'm just wanting to see if anyone knows how to go about on getting my pins to stick in the B and C cause I don't want to just say the hell with it and screw my board up on doing a bonehead thing myself. Thanks for any help I know I kinda ran off on my ranting but if you need any other info I'll post it.

 

[DJBOOBY]

i have herd of this the safes way to fix is to get it soldered in some v1.6 xbox have there hole filled or on hole at all

 

[abrocky]

some 1.6s have extra thick laquer on the boards - filling up the holes required for the Xapt3r's rebuild. Either be very careful and try using something like a fibreglass pen to remove it from the holes...

or better still

Get it soldered as mentioned