Hey, I have recently read this tutorial: http://www.se7ensins.com/forums/threads/jtag-rgh-xbox-360-ultimate-exploit-guide.804054/ and have noticed that in the nand dumping method they use with demon, they tell you to switch the demon to pc, but in the demon instructions they sent with the demon they clearly say to switch the demon to xb, because it can cause damage. When I dump the nand should I switch to xb or pc?
GENERAL xb or pc when dumping the nand
- Thread starter DarkAlex
- Start date
BL4K3Y
VIP Member
The switch must be set to "PC" for the initial test (before installing).
Once the DemoN is installed, you must set the switch to "XB".
Once the DemoN is installed, you must set the switch to "XB".
So I shouldn't do this:
"Now that your DemoN has been installed, it is time to get a dump of your NAND, but MAKE SURE THAT THE SWITCH IS ON "PC". First you will need to plug in the thing so get out your Micro-USB cable and plug it into the port on the side, and plug the other end into your computer."
"Now that your DemoN has been installed, it is time to get a dump of your NAND, but MAKE SURE THAT THE SWITCH IS ON "PC". First you will need to plug in the thing so get out your Micro-USB cable and plug it into the port on the side, and plug the other end into your computer."
Last edited:
BL4K3Y
VIP Member
As I said, the switch must be set to "XB" at all times when the DemoN is installed in the console.
You connect a USB cable to the external module to read/write to the DemoN's NAND.
You connect a USB cable to the external module to read/write to the DemoN's NAND.
Last edited:
Utmad
VIP Member
And when writing the ecc to the demon's nand, it should be set to xb and the power supply should be connected?
Martin C
VIP Member
It's real simple. Once the DemoN is soldered to the console, it should be set to XB and NEVER changed.
Martin C
VIP Member
Martin C
VIP Member