xbox 1.6 with x2.6 Lite will not power on

laihoan

Full Member
Dec 28, 2004
30
0
texas
Hello all,

This is what I am having trouble with.

I installed a xecuter2.6lite into a 1.6xbox and flashed with 1mb bios consisting of 2x256k flashbios 3.0.1 and 2x256k of M8+ 1.6 137+ and all went well. All banks boots as it should and new drive install flawlessly.

Installed about 70gig worth of games and in the middle of it, xbox auto shutoff. Turn it back on and continue to transfer more games. after a few minutes xbox auto shutdown again. Try to reboot with power button but nothing happend. Check power cable and all and all seems good. Power up with DVD eject button and xbox attempt 3 boots then frag. Nothing on screen not even statics. DVD will not eject to try booting with DVD disc. No disc in drive at this time.

Turned off the mod chip and use power button, no sign of power. Used dvd button and it does the same thing......3 boot attempt then frag.

I Did a little of searching but have not found anything. Please help out or direct me to right place to resolve this.

Thanx in advance to all ya geniuses.
 

laihoan

Full Member
Dec 28, 2004
30
0
texas
should the xbox work when bad istall chip is in disable mode?

Chip was working fine. Now even with chip off, the darn thing still frag.
 

laihoan

Full Member
Dec 28, 2004
30
0
texas
hmm, redid the solder and it still does the same thing. I took the chip out completely. took forever to clean up all the solder and the xbox seems perfectly fine now.

Ok it is back to putting back the chip now i guess.
 

laihoan

Full Member
Dec 28, 2004
30
0
texas
I removed the chip and pin header completely, test xbox, xbox ran perfectly so i reinstall chip and all fine and dandy now. Thanx much guys