XBOX booted up, X3 stays red...

[dooper]

version 1.6 xbox
xecuter 3 ce chip...
xbox boots up red... I see the 2 leds on the card though...
But when I QUICLY tap power on, it boots up for a second and cuts off then the ejct starts blinking.........

 

[sdi_guy]

I am experiencing the EXACT same problem...see my thread "Doesnt seem to recognize X3"....let me know if you find a solution...I will do the same...I've tried everything that were suggested to me...but so far no luck...

 

[icecreamguys]

Need to check your D0 point.

Sounds like it is not soldered properly.

EDIT: I didn't read your post fully.

Need to check the connections on your Pin Header

 

[Vol4Ever]

Try this. Tape a wire to the D0 point, and tape the other end to a ground point (one of the screws, for example). Don't solder just yet. That method works for me, but I don't necessarily like it as a permanent solution.

Just curious if it would work for you too.

EDIT: By the way, please post your results in this thread:

http://www.teamxecuter.com/forums/showthread.php?t=25384

There are too many threads on this exact same topic to keep track of. Thanks!