So I just finished RGH'ing my falcon motherboard. Before when I created the ecc and wrote the ecc, I booted into xell to get my cpuy key. Then I out in the cpu key, Created Xebuild image, and wrote the Nand. I did get an error for a block but I just left it like that because before I got nands were the same with 2 errors of the same on every nand. So then when I turned my xbox on with the fan and all it boots instantly. When its on and I move the wires or something the fan and video display would go dead. Then I have to disconnect the power plug and reconnect it then it will turn on. Ive tried to use Xex Menu1.2 but it didnt let me. It shows as a corrupted file and only gives the option of deleteing it. When I tried booting into xell it booted to dashboard instantly. Should I re do the programming and other again?
Xbox Falcon RGH2 Help
- Thread starter TrukfitModz
- Start date
scott1503
VIP Member
john mathews
VIP Member
jumper 1 and 2 needs bridged and u need to fix stby clk wire looks bridged and wheres the jr logs
Last edited:
jsinger47
Troll Eating Dogs
I am redoing the rgh2 proccess and now im trying to boot into xell, i just wrote xell and its taking really long. looks like its not booting
looks like you have switch on SLIM in place of PHAT and bridge jumpers 1-2 not 2-3. leave CAP as is.
the only way my jaspers booted was this combination. falcon should go this way to. but they booted hell long... like 4-6 minutes... but they booted...
the only way my jaspers booted was this combination. falcon should go this way to. but they booted hell long... like 4-6 minutes... but they booted...
I have it set on slim because I'm using timing file B, removed point c8 and are using the blue slim wire for CPU rst cable
john mathews
VIP Member
doest matter u can try phat and slim position go with the 1 that works/ falcon timing file with switch tio slim worked best on every rgh2 falcon I did and jumper 1/2
Last edited: