Xbox Flashing to LT2.0 (BenQ)

[Fuzzy]

Hi all I got a PHAT Xbox 360 with a BenQ VAD6038 drive.. I want to update to LT2.0+ (I got LT 1.1+ now)..

How do I do that the easiest way? Is there an exact tutorial like in the good old days..

My current Dash is 2.0.12625.0

My second problem is that I dont got a valid "flash" card anymore. I got a new motherboard since the LT 1.1+. What is the easiest way to get it working again. Anyone know a PCI card with flashing compatibility that works?

 

[dj_deknoi]

Download the Latest Jungle flasher mate, inside the folder there's a JFtut.pdf, Best tutorial on flashing your xbox long has you read it carefully and follow it. Also remember Goto Stock first, then update daskboard before going to 2.0..Also put your Benqofw, Stock benq, and benq2.0 in the firmware folder

 

[Fuzzy]

Thanks for your answer...

But what can I do when I dont have a compatible "flash" card anymore.

 

[dj_deknoi]

With the benq mate you don't really need additional Hardware, I flash mine by putting my xbox "open" by my pc, ground the Xbox case to my PC case, Remove the sata cable from your Benq drive and Put the sata cable from you PC to the Dvd drive, Open jungle flasher and follow the tutorial mate
NOTES: 100% make sure you have AV cable in xbox, your xbox will Turn off without AV cable in afew minutes, deadly if its powering your drive..
Read the tutorial Carefully, your tutorial Starts on PAGE 38; read slowly, no mistakes..
Remember GET your OFW of your drive.. If you have the lastest dashboard update then accept the Auto Load Firmware... In the Target double check its loaded Benq2.0...
and continue hope this helps mate