Xbox nand wont boot -Glitch or Retail

[Dicko316]

i did write the retail image to both the Stock & demon NANDS.

I only wrote the RGH for additional logging.

d**ko....

Why do I have to retouch the solder points... Can you see something wrong?

It normally helps when you have problems booting.
On your picture, it looked as if point D0 and D7 where not Making Full contact. Just touch them up with a fine tiped soldering iron, add a bit more solder and flux and try again, It can't hurt can it.

 

[Martin C]

ok - here's the problem.

If you're writing the retail NAND to the console, it will do either one of two things:

1. Boot to dashboard.
2. Red light.

Yours is doing neither. Therefore either you've gotten completely confused with which image you have where, or there's something very wrong with your soldering.

I suggest checking all DemoN solder points for continuity and ensure no adjacent points are shorted. The fact you can boot RGH on both NANDs tells me it's ok however that would mean you've messed up your retail NAND.

 

[advancedservers]

if I flash the Retail Image to demon NAND it boots fine which is what confuses me.

I will retouch d0 and d7.

---------- Post added at 04:38 ---------- Previous post was at 04:31 ----------

i can post my retail Image if it would help.

 

[Martin C]

Don't re-touch anything.

Do as advised and check with a meter.

 

[advancedservers]

Hi, I retouched all Quick solder points and it now boots!!!

Thanks for all your help, I really appreciate it.