RGH xbox not booting stock nand

[marcin888888]

if u updated then it must be something wrong with your lvd

 

[Dicko316]

Try and get some better pictures mate. Ones where you can actually tell if the connection between the wires and solder points is good.
Have you tested continuity between the E & F points and made sure they are connected to the correct pads on the CR? Also one fo those wires looks burnt up?!?
A picture of the yellow wire and its route.
Don't use the reset cleaner untill you have it actually glitching too.

 

[abyss]

if u updated then it must be something wrong with your lvd

hey my lvd's are: glitch 10 and retail 11

Try and get some better pictures mate. Ones where you can actually tell if the connection between the wires and solder points is good.
Have you tested continuity between the E & F points and made sure they are connected to the correct pads on the CR? Also one fo those wires looks burnt up?!?
A picture of the yellow wire and its route.
Don't use the reset cleaner untill you have it actually glitching too.

will try to get another camera to take pics mate.
and will test those points now
yes they are on the correct paths on the CR
and no its just some tape with a black marker stipe on it to know which wire id which because E and F are the same colour.
and for the yellow one i'd have to remove my cpu cooler but will make a pic ofit.

 

[abyss]

sorry for a late reply to this but i was bussy and a verry ill the last month.
but i tried it again but after the last few tries the green led became dimmer and dimmer and now doesn't work anymore or the CR died. how can i test this?

 

[Martin C]

The power light is directly indicative of the soldering you've carried out. I suggest getting a meter and checking your Coolrunner is getting the correct voltages.

 

[abyss]

the power led works. it's the green led that became dimmer and not showing again.
but i will measure the power cable through. maybe it's because i have the original RGH qsb?

 

[Martin C]

in which case, why have you STILL not posted clearer images???

It's just a waste of time to bump a thread and have nothing new to input when you were asked for images.

 

[Antalpromille]

yep the wiring is for rgh 2

edit: but i don't understand why it would be the wiring because it glitched fine when the stock nand wasn't working..

So at first after update, the glitch nand booted and the stock didnt. And then, just like that it stopped glitching but stock nand started working? What did you do? Nobody will belive it just changed by it self, so you must have done something.