Xbox one GSOD

[LoAngl]

Hi,
I got an xbox one I need to repair.
I get the green screen of death (green screen with xbox logo) after turning on and it stays like that. The controller does connects to the unit as if everything was normal.

I tried the three different recovery files (OSUDT1, OSUDT2, Factory reset) explained on the microsoft support page. Two of them do nothing. The other one makes the machine turn off with an E101 error.

I'm wondering if this could be fixed with any nand flashing procedure and if there is any hardware I'd need I'd have not problem buying it unless I could do with my nand-x.

Thx

 

[stucknvegas]

Are you doing the factory reset correctly Do you get the fast picture of the controller on the screen
The one I did. I had the controller hooked up hard wire.. Then as the controller picture appeared I hit the controller guide button
Just curios when you ran OSUDT2 update repair did the update status bar show up on the TV screen
When following the update repair for OSUDT2 do you get the sound beeps 15 seconds apart

 

[LoAngl]

I never get the progress bar neither have ever seen the pictured controller.
With two of the off line restore files I get nothing. Just stay there like nothing happens, when it's suppossed to beep after about 10 seconds. Which, according to MS tutorial, is an indication that it's not working.
With the other restore file the xbox turns off after a few seconds from turn on and gives the the E101 error.

I'm sure I'm doing the procedure correctly

 

[stucknvegas]

You have the extracted file in the root of a NTSF formatted USB stick
The file properties 1.86 gig ...and the file is named $SystemUpdate

 

[LoAngl]

Yea sir.

 

[stucknvegas]

Looks like your covered the bases. I have only done that Repair one time it is not like I am the expert or anything
Hopefully someone else will chime in and help you out

 

[LoAngl]

Yes, much appreciated.