So I am trying to do the rgh and I was soldering and destroyed 2 pads is there anyway i can fix this. I also couldn't write original nand and then It worked with jrunner but then I got solid red light and now I cant even write or erase the nand with jrunner and nand pro. I posted pics of the pads
xbox slim Damaged pads
- Thread starter dil_king
- Start date
Do a search in this forum and also google there are lots of posts regarding ALTERNATIVE POINTS..
Good luck
Good luck
ye but those parts being damaged do they affect the ability of my xbox turning on cause its not turning on and I know the alternate points
Damaging those points will render the box unable to boot. You knocked off some resistors it looks like at this point I'd send it to a pro. You have ripped up pads as well so you will need to install standard resistors instead of smds. If you screw that up your box is done. Your decision send it to a qualified tx member or possibly destroy the box.
keil423
VIP Member
That looks like an easy fix to me. First thing you need to do is replace all the missing resistors there. Then most likely you'll need to repair the trace to the Stby. I know I can get it fixed up for you but there are other here that are located in Canada.
Post a request for service in the trader section. Someone near to you might respond. Otherwise hit me up.
Post a request for service in the trader section. Someone near to you might respond. Otherwise hit me up.
Please do a search man...
c here..
http://team-xecuter.com/forums/showthread.php?t=76995
http://team-xecuter.com/forums/showthread.php?t=74992
c here..
http://team-xecuter.com/forums/showthread.php?t=76995
http://team-xecuter.com/forums/showthread.php?t=74992
No u have to fix it...may be better to get some pro to fix it...it will save u lot of money (u already damaged the board not again )
Where in Canada are you? Coolshrimp has quite a bit of rep, I've never seen his work but know the names quite well. There are several of us willing to help for nothing, just cover shipping.
Sent from my LG-P999 using Tapatalk
Sent from my LG-P999 using Tapatalk
Don't. You need to practice soldering man, you won't have much luck on the new one either.
Are you using flux and a soldering station or no flux and a crappy Radio Shack iron.
If you aren't a pro I would not even bother if the latter is true. Just some friendly advice.
What city are you from, I am just outside or Toronto. I can fix this for you. Let me know.
And let him finish the RGH install before the console is perminantly damaged. That can easily be repaired by someone with half decent soldering abilities.
In your shoes I would rather give in and pay someone than have a dead 360. Don't go and attempt it on another 360, you have damaged this one already (but not perminantly, it can be fixed), don't go doing the same to another one.