Xbox Slim Powers Up and Boots but not lights on ROL

ariesone

Junior Member
Dec 4, 2011
13
0
Hi all, I need some help as I don't know whats going on with my console. Basically, its a slim corona v2 and I did an RGH on it. Console worked great until now....

When I power up the console, it beeps, and the console boots to the dash but, there is no green lights at all on the ROL and I am unable to sync my control. First thought was to test the actual ROL however, it works fine with another console and when I swap it, same situation. I have even removed my wiring with no effect. In any event, if there was a fault with the wiring, the console won't boot in the first place.

Is there anything I can look at, perhaps certain resistors?

Thanks all in advance.
 

Nintendo

VIP Member
Sep 5, 2014
605
33
Spain
Hi all, I need some help as I don't Know whats going on with my console. Basically, its a slim corona v2 and I did an RGH on it. Console worked great until now....

When I power up the console, it beeps, and the console boots to the dash but, there is no green lights at all on the ROL and I am unable to sync my control. First thought was to test the actual ROL however, it works fine with another console and when I swap it, same situation. I have even removed my wiring with no effect. In any event, if there was a fault with the wiring, the console won't boot in the first place.

Is there anything I can look at, perhaps certain resistors?

Thanks all in advance.
Is the chip removed? If not, flash the original nand and remove all your soldering.

Do you have a wired controller? Does it work?

What chip are you using?

Have a nice day.
 
Last edited:

ariesone

Junior Member
Dec 4, 2011
13
0
Is the chip removed? If not, flash the original nand and remove all your soldering.

Do you have a wired controller? Does it work?

What chip are you using?

Have a nice day.
Yes, the chip was removed and console flashed with original nand. I was using a CR3 lite. I have rgh'd roughly about 35 consoles and this is the first time I have encountered this. I have also tested the console with another power brick in case of a damaged bricked, however, results are the same.