Xbox slim Red Dot after Demon Install

shawnunder7

Full Member
Jul 19, 2012
73
8
Astoria, NY
Hello all,

Today, i installed a Demon on a slim console that was previously rghed. I tested the demon before hand and updated it. I installed it and i wrote the original nand dump of the xbox to the demon, to which it booted both the original nand and the glitch image. After that, i wrote the original nand back to the xbox and the glitched image to the Demon. After doing that, i tested the console again and it got Red Dot when booting stock nand and infinitely glitches when on the Demon side. I tried a bunch of things, but nothing works for me. Here are pictures of my install





 

shawnunder7

Full Member
Jul 19, 2012
73
8
Astoria, NY
try reflashing your coolrunner with the demon and make sure the demon installed box at the bottom is checked. see if that helps or not.
I tried that, but it didn't work. I also tried writing back the original nand using my jrunner and remocving the CoolRunner and that didn't work either. Thing was working fine before i put it in the case and wrote the nand back to the motherboard. As of now, i closed it up because my back hurts from slouching infront of it for a good 6 hours. I'll try some other stuff in the mornin'
 

Justice1231

VIP Member
May 4, 2011
1,005
0
Adelaide, Australia (down south)
Fair point, after haveing a better look maybe some of the demon cable which are attached to the nand could do with being a little shorter, also the brown cable attached to the demon looks like it could be touching the orange cable below it.
 

shawnunder7

Full Member
Jul 19, 2012
73
8
Astoria, NY
Fair point, after haveing a better look maybe some of the demon cable which are attached to the nand could do with being a little shorter, also the brown cable attached to the demon looks like it could be touching the orange cable below it.
Alrighty, will shorten up and clean up the cables and routing and post results!