Xbox Stopped Working

[zombie666]

I have an V1.1 Xbox with an Xecuter 2.3 Lite installed. Today, I was playing a game of NFL2K5 online when in the last quarter the game crashed on me, at first I thought it might have been the other player disconnecting from the game, but the frame that it was stuck on did not change. I left it for about 5 mintues and came back to find it still stuck on the same frame, so I pressed the eject button and it attempted to reset, but no longer brought up the MS dash. I tried several times thereafter and it will either frag three times with the red led flashing on third frag or it will boot with nothing showing on screen. Since I was playing online I had the chip powered off, but when I now try to boot with the chip on, it still frags the same way. Since the Xbox is out of warranty because it's an old system and because of the mod, what should I do? Has anyone had this problem before?

 

[zombie666]

Another thing that I noticed was that the green led on the chip that shows the connection to the D0 lights up sometimes. When it does it usually follows through with the boot cycle without showing anything on TV screen. When the light doesn't come on is when it frags. I'm assuming something happend when I hit the eject button instead of turning off the power when the game crashed. The only reason being is when I try to power the system on using the eject button, the drive door does not open and it usually frags to the blinking red led. Sometimes though it will just completly shut off. Hope someone can help.

 

[fjbm97]

What type of installation you got?? Pin Header or Cable??... also why don't you give it a GOOD check to the D0 point...

 

[zombie666]

Pin Header, DO is fine checked three times.

 

[catogtp]

what happens when you disable the chip?

 

[zombie666]

same thing