alright, heres the story, i just got an X3 chip. I then install it to my xbox and it boots up to the flashing screen. I flashed it with FlashBIOS version 3.03 via FTP, but have been having some connectivity problems w/ my solderless adapter so i put down some electricians tape and it seems to be working fine. then when i go to flash my X3 via ftp again, it doesn't give me the address of what website to go to to flash it like i did when i was flashing it w/ FlashBIOS 3.03. after hours of troubleshooting, i decided to take out the modchip and put it back together like it wasnt ever opened. now it doesnt work! when i boot up my xbox it shows the screen that says to call xbox support. PLZ HELP!!!!!!!!! thx in advance
XBOX totally skrewed need immidiate help!
- Thread starter unrealized
- Start date
Does it give an error number? Also make sure all the cables are properly seated. Most likely you forgot to plug a cable back in or its loose.
No error #, but i did reassemble the xbox several times with no luck 
When the mod chip was in, i could boot up to the FlashBIOS screen, but when i tried to boot up to the M$ screen the xbox lighte flashed red, turned on and off 3 times and FRAGED.
When the mod chip was in, i could boot up to the FlashBIOS screen, but when i tried to boot up to the M$ screen the xbox lighte flashed red, turned on and off 3 times and FRAGED.
jf freezing when i try to read my benq
using vista 64 bit.
net framework 3.5 installed, portio64.sys, using via sata card with drivers removed.
the benq unlocks into vendor mode but when push read it shows the little blue wheel that its loading and then it says that its not responding
it stops almost instantly doesn't go past 0, .
plz ny help would be great thx
using vista 64 bit.
net framework 3.5 installed, portio64.sys, using via sata card with drivers removed.
the benq unlocks into vendor mode but when push read it shows the little blue wheel that its loading and then it says that its not responding
it stops almost instantly doesn't go past 0, .
plz ny help would be great thx
Re: jf freezing when i try to read my benq
try disabling any dvd drive you have in your computer (or physically unplug them) using the device manager
some dvd rom drivers interfere with portio
try disabling any dvd drive you have in your computer (or physically unplug them) using the device manager
some dvd rom drivers interfere with portio
Re: jf freezing when i try to read my benq
so you mean physically remove the drive or just uninstall the drivers?
so you mean physically remove the drive or just uninstall the drivers?
Re: jf freezing when i try to read my benq
Make sure you are using the Primary port on the VIA card.
VIA 6421 Primary Port (3 Port version) - http://xrl.us/bfod46 | 'Sybia' Version (2 Ports) - http://xrl.us/bfqmbb
Make sure you are using the Primary port on the VIA card.
VIA 6421 Primary Port (3 Port version) - http://xrl.us/bfod46 | 'Sybia' Version (2 Ports) - http://xrl.us/bfqmbb
Re: jf freezing when i try to read my benq
thx for the help joesinger47 and ldngeez
turns out I had to plug it into the primary port like you said Ldn
funny cause I flashed my ms28 on one of the other ones
well thx again
thx for the help joesinger47 and ldngeez
turns out I had to plug it into the primary port like you said Ldn
funny cause I flashed my ms28 on one of the other ones
well thx again