Hello all, I just installed and xecuter 2.6ce into an xbox v1.1 and I don't think it went well, the xbox still works when I switch the chip off, so all is not lost 
I have checked quite a few troubleshooting guides, which all say check the solder points, which I have done quite a few times now. There seems to be no power to the modchip (as no lights are appearing on it or the switch bank), all it does is reboot 3 three times and then frag.
Do you think it's likely that I just have a damaged modchip? Or is my soldering work not up to scratch?
Any suggestions on how to resolve this issue would be appreciated. Thanks in advance.
I have checked quite a few troubleshooting guides, which all say check the solder points, which I have done quite a few times now. There seems to be no power to the modchip (as no lights are appearing on it or the switch bank), all it does is reboot 3 three times and then frag.
Do you think it's likely that I just have a damaged modchip? Or is my soldering work not up to scratch?
Any suggestions on how to resolve this issue would be appreciated. Thanks in advance.