RGH Xbox will not boot..

[Musad]

[FONT=&quot]I have a Falcon that I installed the CoolRunner on and was working fine for about a month, did not use it much maybe once or twice a week.[/FONT]
[FONT=&quot]I tried to Boot the XBOX and nothing. [/FONT]

[FONT=&quot]The CoolRunner: [/FONT]
[FONT=&quot]Red Led ON [/FONT]
[FONT=&quot]Green Rest Glitch Led : Does not light[/FONT]


[FONT=&quot]So I flashed the original NAND and removed the 3.3V Red wire from the CR.[/FONT]

[FONT=&quot]This time I get 3 RROD with secondary code of 0110.[/FONT]

[FONT=&quot]Should I assume that this console needs a reflow?[/FONT]


[FONT=&quot]Thanks in advance.[/FONT]
[FONT=&quot]m
[/FONT]

 

[Goldensavage]

0110 Memory Error / Memory Overheating - see solution for error 0102

0102 unknown error
though it's most likely GPU related literally means the console does not know what is wrong. possibly a short or cold solder joint somewhere. So far there is 1 major theory for what causes most of these errors is that the Ram, CPU, or GPU are not soldered properly to the mother board due either to poor manufacturing or excessive heat up and cool down cycles that stress, weaken and eventually break the soldered connection.
There are two theories to fixing this one deals with the "X" clamps that hold down the chips. The other involves re-Heating the chips. DO NOT attempt either of these if your console is still under warranty. If your console is still under warranty return it to the store where it was purchased or call MS to have it replaced. I have also heard of limited success by simply switching the AV cable from "HDTV" mode to "TV" mode.

Yeah, looks like reflow time.

 

[Musad]

Thanks Golden..

m

 

[oO Elite Oo]

I believe Martin C said something about not grabbing the motherboard by the heat sinks as this causes RROD. Reflow yes.

 

[DayvG]

Where you there when he removed the mobo then? Just wondering how you deduced that from the OP.