ANSWERED Xebuild V1.0 GUI + Rawflash V3 confused

[studiovpc]

I used Xebuild V1.0 GUI to make glitch image with new dash 14699 and flashed it back via Rawflash V3, but bumped into 3 bad blocks, all are continuos 3 one after another. I checked the image with several tools there were no bad blocks whatsoever, checked with 360 Flash tool to see what those blocks are and they seem to be empty ones.
Original nand is Jasper BB 512 CB6750, dumped only 64MB, 3 times, compared, all were ok during the dump with no bad blocks...

btw everything is working fine, new dash boots fine, fsd works, all games are working etc...

any thoughts why rawflash v3 shows these blocks?

 

[Martin C]

Status 240 is empty block. It assumes an empty block is a problem, however a recreated NAND might have padding which means you could have empty blocks.

In short, you should be ok to ignore it.

 

[studiovpc]

as I said everything is fine, just wanted to check out here thank you Martin

 

[Martin C]

No worries. Thread closed as resolved.