xecuter 2.6 problem

[sbeeze]

i have installed via the pinheader install on my 1.0 xbox, my problem is that i just boot to the m$ dash as ifthe xbox was stock, i have checked my d0 line 3 times over and tried both top and bottom but still no luck. i have also tried 2 other chips to see if maybe it was a bad chip (LT OPX, Duo X2) but i get the same result. what can i do? could the lpc be damaged? should i solder to alternates on the board and just skip over the lpc all together? any ideas?

 

[B19J0N]

Check your lpc points with a continuity checkerwith each corresponding point on the mobo and does your chip light up at all when the xbox boots up?