Xecuter 2.6 with 1.6 solderless adapter problems

[punk000]

Ok i hav just cought the Xecuter 2.6 and the Xapt3r 1.6 solderless adapter and hav installed both fine. when turned on flashbios screen comes up then i flashed banks 1 and 2 with *x2_5035_v16plus_512k.bin*, flashing went great once it finished it turned off, i turned it bak on like it says in many tuts but i kept getting the flashbios screen again. So decided to flash both banks again. But now when the chip is turned on it starts to frag and when the chip is off it loads up to a screen with *05* in the corner and says " Service required. Call customer support "

Can any1 help me out plz, hav looked on loads of sites for this problem but cant find a solution, would appreciate it alot, thanx.

 

[digthebox]

Okay one thing I can tell you is Error 5 means hard disk is not locked!!!

When the chip is off your xbox boots from the reatil microsoft bios and this bios requires your had disk to be locked.

Have you either replaced the hard disk or did you unlock it with flashbios?

Let's see if we can get your xbox to atleast boot back to reatil mode first, then we will see about your frag.

 

[punk000]

Yeh i think i did unlock it with flashbios!!

How do i go about trying to lock it again???

 

[Nothingness]

you need a working flash to stop the fragging... and since u have a 1.6, you should have the right bios... did you buy a programmer with your 2.6?

 

[punk000]

Thot i might need one so i bought a programmer yestarday.